Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1612
AMF Commands
Software Reference for x310 Series Switches
60.24
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
Several checks are performed to ensure the upgrade will succeed. These include checking
the current node release boots from flash. If there is enough space on flash, the software
release is copied to flash to a new location on each node as it is processed. The new
release name will be updated using the "boot system
old release will become the backup release file.
On bootup the software release is verified. Should an upgrade fail, the upgrading unit will
fail back to old software. At the completion of this command, a report is run showing the
release upgrade status of each node.
This function is supported on the following switches: AT-SBx908, SBx8100 Series, x610
Series, x510 Series and AT-IX5-28GPX. It is supported on all stack configurations.
Example-1
To reboot all x510 nodes in an AMF network, use the following commands
This command returns the following type of screen output:
Note
If you are using TFTP, HTTP, etc, to access a file on a remote device, then the URL
should specify the exact release filename without using wild card characters.
Note
Take care when removing external media or rebooting your switches. Removing
an external media while files are being written entails a significant risk of causing
a file corruption.
Bld2_Floor_1#
atmf working-set group x510
===================
node1, node2, node3:
=====================
Working set join
AMF_NETWORK_Name[3]#
ATMF_NETWORK[3]#
atmf reboot-rolling