Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1964)

LLDP Commands
Software Reference for x310 Series Switches
71.38 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Related Commands show lldp
show running-config lldp
Table 71-3: Parameters in the output of the show lldp interface command
Parameter Description
Port Port name.
Rx Whether reception of LLDP advertisements is enabled on
the port.
Tx Whether transmission of LLDP advertisements is enabled on
the port.
Notif Whether sending SNMP notification for LLDP is enabled on
the port:
■ RM = Remote Tables Change Notification
■
TP = LLDP-MED Topology Change Notification
Management Addr Management address advertised to neighbors.
Base TLVs Enabled
for Tx List of optional Base TLVs enabled for transmission:
■
Pd = Port Description
■
Sn =System Name
■ Sd = System Description
■ Sc =System Capabilities
■
Ma = Management Address
802.1 TLVs
Enabled for Tx List of optional 802.1 TLVs enabled for transmission:
■ Pv = Port VLAN ID
■
Pp = Port And Protocol VLAN ID
■
Vn = VLAN Name
■
Pi =Protocol Identity
802.3 TLVs
Enabled for Tx List of optional 802.3 TLVs enabled for transmission:
■
Mp = MAC/PHY Configuration/Status
■
Po = Power Via MDI (PoE)
■
La = Link Aggregation
■ Mf = Maximum Frame Size
MED TLVs Enabled
for Tx List of optional LLDP-MED TLVs enabled for transmission:
■
Mc = LLDP-MED Capabilities
■
Np = Network Policy
■ Lo = Location Information,
■ Pe = Extended Power-Via-MDI
■
In = Inventory