Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 231)

System Configuration and Monitoring Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 8.31
show debugging
This command displays information for all debugging options.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show debugging
Default This command runs all the show debugging commands in alphabetical order.
Mode User Exec and Privileged Exec
Usage This command displays all debugging information, similar to the way the show tech-
support command displays all show output for use by Allied Telesis authorized service
personnel only.
Example To display all debugging information, use the command:
Output Figure 8-5: Example output from the show debugging command
Related Commands show debugging aaa
show debugging dot1x
show debugging epsr
show debugging igmp
show debugging lacp
show debugging lldp
show debugging mstp
show debugging power-inline
show debugging radius
show debugging snmp
awplus# show debugging
awplus#show debugging
AAA debugging status:
Authentication debugging is off
Accounting debugging is off
% DHCP Snooping service is disabled
802.1X debugging status:
EPSR debugging status:
EPSR Info debugging is off
EPSR Message debugging is off
EPSR Packet debugging is off
EPSR State debugging is off
IGMP Debugging status:
IGMP Decoder debugging is off
IGMP Encoder debugging is off
.
.
.