Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 562)

Link Aggregation Introduction and Configuration
Software Reference for x310 Series Switches
20.6 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
awplus(config-if)#
exit Exit the Interface Configuration mode and
return to the Global Configure mode.
awplus(config)#
interface port1.0.3 Enter the Interface Configuration mode to
configure port 1.0.3.
awplus(config-if)#
channel-group 1 mode active Add this interface to a channel group 1 and
enable link aggregation so that it may be
selected for aggregation by the local system.
awplus(config-if)#
interface po1 Select the dynamic aggregator logical
interface created for channel-group 1 named
po1
.
Table 20-2: Switch 2 configuration
awplus#
configure terminal Enter the Global Configuration mode.
awplus(config)#
lacp system-priority 3000 Set the system priority of this switch. This
priority is used to determine which switch in
the system is responsible for resolving
conflicts in the choice of aggregation groups.
A lower numerical value has a higher priority.
Switch 2 has a lower priority than Switch 1 in
this configuration.
awplus(config)#
interface port1.0.2 Enter the Interface Configuration mode to
configure port 1.0.2.
awplus(config-if)#
channel-group 1 mode active Add this interface to a channel group 1 and
enable link aggregation so that it may be
selected for aggregation by the local system.
awplus(config-if)#
exit Exit the Interface mode and return to the
Configure mode.
awplus(config)#
interface port1.0.3 Enter the Interface mode to configure port
1.0.3
.
awplus(config-if)#
channel-group 1 mode active Add this interface to a channel group 1 and
enable link aggregation so that it may be
selected for aggregation by the local system.
Table 20-1: Switch 1 configuration (cont.)