Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 763)

IGMP Snooping Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 31.25
ip igmp snooping routermode
Use this command to set the destination IP addresses as a router multicast address,
according to the routermode (all multicast addresses, default multicast addresses,
specified multicast addresses).
Use the no variant of this command to the default. You can also remove a specified IP
address from a custom list of multicast addresses.
Syntax ip igmp snooping routermode {all|default|ip|multicastrouter|address
<ip-address>}
no ip igmp snooping routermode [address <ip-address>]
Default The default routermode is default not all and shows the below reserved multicast
addresses:
Mode Global Configuration
Parameter Description
all All reserved multicast addresses (224.0.0.x).
Packets from all possible addresses in range 224.0.0.x are set as
routers.
default Default set of reserved multicast addresses.
Packets from 224.0.0.1, 224.0.0.2, 224.0.0.4, 224.0.0.5, 224.0.0.6,
224.0.0.9, 224.0.0.13, 224.0.0.15 and 224.0.0.24 are set as
routers.
ip Custom reserved multicast addresses.
Custom IP address in the 224.0.0.x range are set as router
multicast addresses using the ip igmp snooping routermode
address command.
multicastrouter DVMRP (224.0.0.4) and PIM (224.0.0.13) multicast addresses are
set as routers.
address Specify the multicast address in the 224.0.0.x range for use
after issuing an ip igmp snooping routermode ip command
IPv4 multicast address (224.0.0.x)
Router mode.............Def
Reserved multicast address
224.0.0.1
224.0.0.2
224.0.0.4
224.0.0.5
224.0.0.6
224.0.0.9
224.0.0.13
224.0.0.15
224.0.0.24