Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2162)

Stacking Commands
Software Reference for x310 Series Switches
83.22 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
stack renumber
Use this command to renumber a specific stack member.
Syntax stack <existing stack-ID> renumber <new stack-ID>
Default Every stack unit will initially try to use a stack-ID of 1.
Mode Global Configuration
Usage This command is used to change the ID of a specific stack member - primarily when
exchanging stack members. The changes made by this command will not take effect until
the switch is rebooted.
The existing stack-ID must already be assigned to an existing stack member. To avoid
duplicating IDs, a warning message will appear if you assign a new stack-ID that is
currently assigned to another stack member. However, you can continue to renumber the
stack-IDs and remove ID duplications. If you do not remove the duplications, then one of
the devices will be forced to automatically renumber to an unused ID. Once you have
removed any duplicate IDs, you can reboot the switch to implement your changes.
Note that the configured stack-ID is saved immediately on the renumbered member,
and so is not reliant on using the
copy running-config command for it to take effect.
Example To renumber stack 1 to stack 2, use the commands:
Validation
Command show stack
Parameter Description
<existing stack-ID> We recommend that you use only numbers 1 to 2 for
a 2 unit stack, 1 to 4 for a four unit stack, etc.
renumber Change the existing stack-ID.
<new stack-ID> We recommend that you use only numbers 1 to 2 for
a 2 unit stack, 1 to 4 for a four unit stack, etc.
Note This command does not alter any of the stacks's existing configuration, apart
from the stack-ID specified. For example, if stack member 2 were removed
from the stack and a new stack unit is assigned the member 2 stack-ID,
then the interface configuration that existed for the removed stack member 2
will be applied to the new stack member 2.
awplus# configure terminal
awplus(config)# stack 1 renumber 2