Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 502)

Spanning Tree Commands
Software Reference for x310 Series Switches
19.12 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
revision (MSTP)
Use this command to specify the MST revision number to be used in the configuration
identifier.
Use this command for MSTP only.
Syntax revision <revision-number>
Default The default of revision number is 0.
Mode MST Configuration
Usage The region name, the revision number, and the digest of the VLAN to MSTI configuration
table must be the same on all devices that are intended to be in the same MST region.
Example
Related Commands region (MSTP)
show spanning-tree mst config
instance vlan (MSTP)
show debugging mstp
Use this command to show the MSTP debugging options set.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show debugging mstp
Mode User Exec and Privileged Exec mode
Example To display the MSTP debugging options set, enter the command:
Output Figure 19-1: Example output from the show debugging mstp command
Related Commands debug mstp (RSTP and STP)
Parameter Description
<revision-number> <0-65535> Revision number.
awplus# configure terminal
awplus(config)# spanning-tree mst configuration
awplus(config-mst)# revision 25
awplus# show debugging mstp
MSTP debugging status:
MSTP receiving packet debugging is on