Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1952)

LLDP Commands
Software Reference for x310 Series Switches
71.26 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
location civic-location identifier
Use this command to enter the Civic Address Location Configuration mode to configure
the specified location.
Use the no variant of this command to delete a civic address location. This also removes
the location from any ports it has been assigned to.
Syntax location civic-location identifier <civic-loc-id>
no location civic-location identifier <civic-loc-id>
Default By default there are no civic address locations.
Mode Global Configuration
Usage To configure the location information for this civic address location identifier, use the
location civic-location configuration command. To associate this civic location identifier
with particular ports, use the location elin-location-id command.
Up to 400 locations can be configured on the switch for each type of location information,
up to a total of 1200 locations.
Examples To enter Civic Address Location Configuration mode for the civic address location with ID
1, use the commands:
To delete the civic address location with ID 1, use the commands:
Related Commands location civic-location-id
location civic-location configuration
show location
show running-config lldp
Parameter Description
<civic-loc-id> A unique civic address location ID, in the range 1 to 4095.
awplus# configure terminal
awplus(config)# location civic-location identifier 1
awplus(config-civic)#
awplus# configure terminal
awplus(config)# no location civic-location identifier 1