Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1920)

LLDP, LLDP-MED and Voice VLAN Introduction and Configuration
Software Reference for x310 Series Switches
70.16 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
18.
awplus(config-coord)# latitude
awplus(config-coord)# lat-resolution
awplus(config-coord)# longitude
awplus(config-coord)# long-resolution
awplus(config-coord)# altitude
{meters|floor}
awplus(config-coord)# alt-resolution
awplus(config-coord)# datum {wgs84|
nad83-navd|nad83-mllw}
Specify the coordinate location for the coordinate
location identifier.
19.
awplus(config-coord)# exit Return to global configuration mode.
20.
awplus(config)# location elin-location
identifier
Specify an ELIN location identifier, and the ELIN
for this identifier.
21.
awplus(config)# interface <port-list>
Enter interface configuration mode for one or
more switch ports which require the same
location information.
22.
awplus(config-if)# location civic-location-id
awplus(config-if)# location coord-location-id
awplus(config-if)# location elin-location-id
Assign the civic, coordinate, and/or ELIN location
identifier to these ports.
LLDP-MED will send the location information
associated with a port to the voice endpoint
device attached to it.
23.
awplus(config-if)# exit Return to global configuration mode.
24.
awplus(config)# exit
Return to Privileged Exec mode.
Review the LLDP configuration
25.
awplus# show lldp Check general LLDP configuration settings.
26.
awplus# show lldp interface []
Check LLDP configuration for ports.
27.
awplus# show lldp local-info [base] [dot1] [dot3]
[med] [interface ]
Check the information that may be transmitted in
LLDP advertisements from ports.
28.
awplus# show location {civic-location|coord-
location|elin-location}
awplus# show location {civic-location|coord-
location|elin-location} identifier {|
|}
awplus# show location {civic-location|coord-
location|elin-location} interface
Check the location information.
29.
awplus# show running-config lldp
If you want to display all the LLDP configuration,
use this command.
Monitor LLDP-MED
30.
awplus# show lldp neighbors [interface
list>]
awplus# show lldp neighbors detail [base] [dot1]
[dot3] [med] [interface ]
awplus# show lldp statistics
awplus# show lldp statistics interface []
Monitor LLDP operation.
Table 70-5: Configuration procedure for Voice VLAN and LLDP-MED(cont.)