Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1632)

AMF Commands
Software Reference for x310 Series Switches
60.44 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show atmf detail
This command displays details about an AMF node.
Syntax show atmf detail
Mode Privileged Exec
Example-1 To display the AMF node1 information in detail, use the command
A typical output screen from this command is shown below:
Parameter Description
show Displays running system information
atmf The Allied Telesis Management Framework (AMF)
detail Displays output in greater depth
node1# show atmf detail
node1#show atmf detail
ATMF Detail Information
Network Name : ATMF_NET
Node Name : Admin2
Node Address : Admin2.atmf
Node ID : 15
Node Depth : 0
Domain State : DomainController
Recovery State : None
AMF-ALL License : Yes
Management VLAN
VLAN ID
: 4092
Management Subnet : 172.31.0.0
Management IP Address : 172.31.0.1
Management Mask : 255.255.128.0
Domain VLAN
VLAN ID
: 4091
Domain Subnet : 172.31.128.0
Domain IP Address : 172.31.128.1
Domain Mask : 255.255.128.0
Table 60-2: Parameter definitions from the show atmf detail command
Parameter Definition
ATMF Status The Node’s AMF status, either Enabled or Disabled.
Network Name The AMF network that a particular node belongs to.
Node Name The name assigned to a particular node.
Role The role configured for this AMF device, either Master or Member.
Current ATMF Nodes The count of AMF nodes in an AMF Network.
Node Address An Address used to access a remotely located node. This is simply the Node Name plus the
dotted suffix atmf (.atmf ).