Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1556)

AMF Introduction and Configuration
Software Reference for x310 Series Switches
59.12 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
.
Table 59-1: Set QoS CoS for an AMF tunneling switch
Description Prompt Command
Step 1. Create VLAN 10.
Enter Global Configuration mode (awplus#) configure terminal
Enter VLAN config mode awplus(config)#) vlan database
Create and enable VLAN 10 awplus(vlan-config)# vlan 10 name virtual-link state
enable
Step 2. Configure VLAN10
Enter the VLAN configuration mode
for VLAN10. awplus(vlan-config)# interface vlan10
Set the IP address for VLAN10 to be
192.168.1.1/24 awplus(vlan-config-if)# ip address 192.168.1.1/24
Return to config mode awplus(vlan-config-if)# exit
Step 3. Add policy map vlink to port 1.0.10
Set port 1.0.10 for configuring awplus(vlan-config)# interface port 1.0.10
Set the port to access mode awplus(vlan-config-if)# switchport mode access
Associate the port with VLAN10 awplus(vlan-config-if)# switchport access vlan10
Add policy map vlink to port 1.0.10 awplus(vlan-config-if)# service-policy input vlink
Return to config mode awplus(vlan-config-if)# exit
Step 4. Create an AMF virtual-link tunnel
Create the virtual link tunnel awplus(vlan-config)# atmf virtual-link id 1 ip
192.168.1.1 remote-id 2
remote-ip 192.168.2.1
Step 5. Create an ACL to permit tunneled traffic
Enable QoS on switch 1 awplus(vlan-config)# mls qos enable
Create an access-list for the virtual
link awplus(vlan-config)# access-list hardware vlink
Permit traffic that has the tunneled IP
addresses awplus(vlan-config-ip-
hw-acl)#
permit ip 192.168.2.1/24 ip
192.168.1.0/24
Step 6. Create a class-map for the virtual link
Create a class-map named vlink awplus(vlan-config)# class-map vlink
Step 7.
Create a class-map named vlinkarp awplus(vlan-config)# class-map vlinkarp
awplus(config-cmap)# match eth-format ethii-any
protocol 0806