Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1748)

DHCP for IPv6 (DHCPv6) Introduction and Configuration
Software Reference for x310 Series Switches
65.12 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Configure DHCPv6 Stateful Client (Prefix)
In this example, a stateful client can obtain its interface address (via DHCPv6 IANA) and
other information (such as DNS, SNTP) configured in the DHCP Server delegation pool.
■ The client is allocated an address from the address prefix configured in the DHCP
Server pool. A stateful client can automatically learn about any gateway router(s) on
the LAN and dynamically add associated default route(s) into its routing table via
next-hop link-local address of the gateway router via router advertisements.
■ RA suppression is turned off in the DHCPv6 Server to facilitate neighbor discovery.
For command information, see the ipv6 address dhcp command on the Stateful Client.
Note bold configuration command entries show hostnames and interfaces.
Also note the default VLAN interface vlan1 is applied to all ports on a device.
Figure 65-4: DHCPv6 Stateful Client configuration topology:
Stateful_Client Configuration (IANA)
See the below configuration for a device with the hostname Stateful_Client:
hostname Stateful_Client
!
interface vlan1
ipv6 address dhcp
dhcpv6_stateful_client1
Stateful_Client DHCPv6_Server
vlan1