Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1532)

EPSR Commands
Software Reference for x310 Series Switches
58.6 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
epsr mode transit controlvlan
This command creates a transit EPSR instance.
Syntax epsr mode transit controlvlan <2-4094>
Mode EPSR Configuration
Example To create a transit EPSR instance called blue with vlan2 as the control VLAN, use the
command:
Related Commands epsr mode master controlvlan primaryport
epsr mode transit controlvlan
show epsr
Parameter Description
Name of the EPSR instance.
mode Determines the node is acting as a transit node.
transit Sets switch to be the transit node for the named EPSR ring.
controlvlan The VLAN that will transmit EPSR control frames.
<2-4094> VLAN id.
Note The software allows you to configure more than two ports or static channel
groups to the control VLAN within a single switch or stacked node. However,
we advise against this because in certain situations it can produce
unpredictable results.
If the control VLAN contains more than two ports (or static channels) an
algorithm selects the two ports or channels with the lowest number to be the
ring ports. However if the switch has only one channel group is defined to the
control vlan, EPSR will not operate on the secondary port.
EPSR does not support Dynamic link aggregation (LACP).
awplus(config-epsr)# epsr blue mode transit controlvlan vlan2