Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1159)

Authentication Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 43.33
auth-web enable
This command enables Web-based authentication in Interface mode on the interface
specified.
Use the no variant of this command to disable Web-based authentication on an interface.
Syntax auth-web enable
no auth-web enable
Default Web authentication is disabled by default.
Mode Interface Configuration for a static channel or a switch port.
Usage Web-based authentication cannot be enabled if DHCP snooping is enabled ( service
dhcp-snooping command on page 56.24 ), and vice versa.
Examples To enable Web authentication on static-channel-group 2, use the following commands:
To disable Web authentication on static-channel-group 2, use the following commands:
Validation
Commands
show auth-web
show auth-web interface
show running-config
Related Commands aaa accounting auth-web default
aaa authentication auth-web
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# static-channel-group 2
awplus(config-if)# exit
awplus(config)# interface sa2
awplus(config-if)# auth-web enable
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# static-channel-group 2
awplus(config-if)# exit
awplus(config)# interface sa2
awplus(config-if)# no auth-web enable