Dot1x eapol-version – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1071

802.1X Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

Operating System - Version 5.4.4C

41.5

dot1x eapol-version

This command sets the EAPOL protocol version for EAP packets when 802.1X port
authentication is applied.

Use the no variant of this command to set the EAPOL protocol version to 1.

The default EAPOL protocol version is version 1.

Syntax

dot1x eapol-version {1|2}

no dot1x eapol-version

Default

The EAP version for 802.1X authentication is set to 1 by default.

Mode

Interface Configuration for a static channel, a dynamic (LACP) channel group, or a switch
port.

Examples

To set the EAPOL protocol version to 2 for port1.0.2, use the commands:

To set the EAPOL protocol version to the default version (1) for interface port1.0.2, use
the commands:

Validation

Commands

show dot1x

Parameter

Description

EAPOL version.

awplus#

configure terminal

awplus(config)#

interface port1.0.2