Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1330)

Local RADIUS Server Commands
Software Reference for x310 Series Switches
51.2 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Command List
This chapter provides an alphabetical reference for commands used to configure the local
RADIUS server on the device. For more information, see
Chapter 50, Local RADIUS
Server Introduction and Configuration .
attribute
Use this command to define a RADIUS attribute for the local RADIUS server user group.
For a complete list of defined RADIUS attributes and values, see “Defined RADIUS
attributes list” on page 50.9 .
When used with the help parameter the attribute command displays a list of standard
and vendor specific valid RADIUS attributes that are supported by the local RADIUS server.
If an attribute name is specified with the help parameter, then the attribute command
displays a list of predefined attribute names. Note that you can only use the defined
RADIUS attribute names and not define your own.
When used with the value parameter the attribute command configures RADIUS
attributes to the user group. If the specified attribute is already defined then it is replaced
with the new value.
Use the no variant of this command to delete an attribute from the local RADIUS server
user group.
Syntax attribute [<attribute-name>|<attribute-id>] help
attribute {<attribute-name>|<attribute-id>} <value>
no attribute {<attribute-name>|<attribute-id>}
Default By default, no attributes are configured.
Mode RADIUS Server Group Configuration
Parameter Description
<attribute-name> RADIUS attribute name for standard attributes (see
Table 50-1 on page 50.10 ) or Vendor-Specific attributes (see
Table 50-2 on page 50.18 ).
<attribute-id> RADIUS attribute numeric identifier for standard attributes
(
Table 50-1 on page 50.10 ).
<value> RADIUS attribute value.
help Display a list of available attribute types.