Show running-config interface – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 186

File Management Commands
Software Reference for x310 Series Switches
7.40
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
show running-config interface
This command displays the current configuration of one or more interfaces on the switch.
For information on output options, see
“Controlling “show” Command Output” on
Syntax
show running-config interface [<interface-list>]
[dot1x|ip igmp|lacp|mstp|rstp|stp]
Mode
Privileged Exec and Global Configuration
Examples
To display the current running configuration of your switch for ports 1 to 4, use the
command:
To display the current running configuration of a switch for VLAN 1, use the command:
Parameter
Description
<interface-list>
The interfaces or ports to display information about. An
interface-list can be:
■
a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by
a hyphen;
e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2, or
po1-2
■
a comma-separated list of the above;
e.g. port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
dot1x
Displays running configuration for 802.1X port
authentication for the specified interfaces.
lacp
Displays running configuration for LACP (Link Aggregation
Control Protocol) for the specified interfaces.
ip igmp
Displays running configuration for IGMP (Internet Group
Management Protocol) for the specified interfaces.
ip multicast
Displays running configuration for general multicast
settings for the specified interfaces.
mstp
Displays running configuration for MSTP (Multiple
Spanning Tree Protocol) for the specified interfaces.
rstp
Displays running configuration for RSTP (Rapid Spanning
Tree Protocol) for the specified interfaces.
stp
Displays running configuration for STP (Spanning Tree
Protocol) for the specified interfaces.
awplus#
show running-config interface port1.0.1-port1.0.4
awplus#
show running-config interface vlan1