Location coord-location configuration, Latitude Page 1954: Longitude
Page 1954: Longitude
LLDP Commands
Software Reference for x310 Series Switches
71.28
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
location coord-location configuration
Use this command to configure a coordinate-based location. All parameters must be
configured before assigning this location identifier to a port.
Syntax
latitude <latitude>
lat-resolution <lat-resolution>
longitude <longitude>
long-resolution <long-resolution>
altitude <altitude> {meters|floor}
alt-resolution <alt-resolution>
datum {wgs84|nad83-navd|nad83-mllw}
Default
By default no coordinate location information is configured.
Mode
Coordinate Configuration
Parameter Description
<lat-resolution>
Latitude resolution, as a number of valid bits, in the range 0 to
34.
<latitude>
Latitude value in degrees in the range -90.0 to 90.0
<long-resolution>
Longitude resolution, as a number of valid bits, in the range 0
to 34.
<longitude>
Longitude value in degrees, in the range -180.0 to 180.0.
<alt-resolution>
Altitude resolution, as a number of valid bits, in the range 0 to
30. A resolution of 0 can be used to indicate an unknown
value.
<altitude>
Altitude value, in meters or floors.
meters
The altitude value is in meters.
floors
The altitude value is in floors.
datum
The geodetic system (or datum) that the specified coordinate
values are based on.
wgs84
World Geodetic System 1984.
nad83-navd
North American Datum 1983 - North American Vertical
Datum.
nad83-mllw
North American Datum 1983 - Mean Lower Low Water vertical
datum.