Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1195)

Authentication Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 43.69
show auth-mac statistics interface
This command shows the authentication statistics for the specified interface, which may
be a static channel (or static aggregator) or a dynamic (or LACP) channel group or a switch
port.
Syntax show auth-mac statistics [interface <interface-list>]
Mode Privileged Exec
Example To display MAC authentication statistics for port1.0.2, enter the command:
Related Commands show dot1x interface
Parameter Description
interface Specify ports to show.
The interfaces or ports to configure. An interface-list can be:
■ an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
■
a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen;
e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2, or
po1-2
■
a comma-separated list of the above;
e.g. port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
awplus# show auth-mac statistics interface port1.0.2