Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 595)

Power over Ethernet Introduction
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 22.11
Software monitoring
There are four PoE show commands available that return information about the PoE
settings on your switch.
The show power-inline command displays the power threshold set, a power usage
percentage, and power consumed by each switch port.
The show power-inline counters command displays PoE event counters from the PoE
MIB (RFC 3621).
The show power-inline interface command displays a summary of all PoE information,
including power limit, power consumed, and power class.
The show power-inline interface detail command displays all PoE information, including
power limit, power consumed, and power class.
You can also specify an individual PoE port, a range of PoE ports, or a selection of PoE ports
with the show power-inline interface detail command when using the <port-list>
option, as shown below for a PoE port, a selection of PoE ports, and a range of PoE ports:
awplus# show power-inline
awplus# show power-inline counters
awplus# show power-inline interface
awplus# show power-inline interface detail
awplus# show power-inline interface port1.0.2 detail
awplus# show power-inline interface port1.0.2,port1.0.4
detail
awplus# show power-inline interface port1.0.2-port1.0.4
detail