Log buffered – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 279
Logging Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
10.7
log buffered
This command configures the device to store log messages in RAM. Messages stored in
RAM are not retained on the device over a restart. Once the buffered log reaches its
configured maximum allowable size old messages will be deleted to make way for new
ones.
Syntax
log buffered
no log buffered
Default
The buffered log is configured by default.
Mode
Global Configuration
Examples
To configured the device to store log messages in RAM use the following commands:
To configure the device to not store log messages in a RAM buffer use the following
commands:
Validation
Commands
Related Commands
default log buffered
log buffered (filter)
log buffered size
awplus#
configure terminal
awplus(config)#
log buffered
awplus#
configure terminal
awplus(config)#
no log buffered