Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 719)

Routing Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 29.5
maximum-paths
This command enables ECMP on your device, and sets the maximum number of paths that
each route has in the Forwarding Information Base (FIB). ECMP is enabled by default.
The no variant of this command sets the maximum paths to the default of 4.
Syntax maximum-paths <1-8>
no maximum-paths
Default By default the maximum number of paths is 4.
Mode Global Configuration
Examples To set the maximum number of paths for each route in the FIB to 5, use the command:
To set the maximum paths for a route to the default of 4, use the command:
Parameter Description
<1-8> The maximum number of paths that a route can have in the FIB.
awplus# configure terminal
awplus(config)# maximum-paths 5
awplus# configure terminal
awplus(config)# no maximum-paths