Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1514)

EPSR Introduction and Configuration
Software Reference for x310 Series Switches
57.32 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Step 14: Add the physical port1.0.2to these VLANs (on Transit Nodes D and E)
Step 15: Add the physical port1.0.3to these VLANs (on Transit Nodes D and E)
awplus(config)#
interface port1.0.2 Specify the physical interface (port1.0.2) that you
are configuring and enter the Interface Configuration
mode.
awplus(config-if)#
switchport mode trunk Set the switching characteristics of this port to Trunk
mode.
awplus(config-if)#
switchport trunk allowed vlan add 40 Enable VLAN 40 on this port.
awplus(config-if)#
exit Exit the Interface Configuration mode and enter the
Global Configuration mode.
awplus(config)#
interface port1.0.3 Specify the physical interface (port1.0.3) that you
are configuring and enter the Interface Configuration
mode.
awplus(config-if)#
switchport mode trunk Set the switching characteristics of this port to Trunk
mode.
awplus(config-if)#
switchport trunk allowed vlan add 40 Enable VLAN 40 on this port.
awplus(config-if)#
exit Exit the Interface Configuration mode and enter the
Global Configuration mode.