Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 583)

Link Aggregation Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 21.17
static-channel-group
Use this command to create a static channel group, also known as a static aggregator, or
add a member port to an existing static channel group.
Use the no variant of this command to remove the switch port from the static channel
group.
Syntax static-channel-group
no static-channel-group
Mode Interface Configuration
Usage This command adds the switch port to the static channel group with the specified channel
group number. If the channel group does not exist, it is created, and the port is added to it.
The no prefix detaches the port from the static channel group. If the port is the last
member to be removed, the static channel group is deleted.
All the ports in a channel group must have the same VLAN configuration: they must
belong to the same VLANs and have the same tagging status, and can only be operated
on as a group.
Once the static channel group has been created, it is treated as a switch port, and can be
referred to in other commands that apply to switch ports.
To refer to a static channel group in other static channel group commands, use the
channel group number. To specify a static channel group in other commands, prefix the
channel group number with sa. For example, ‘sa2’ refers to the static channel group with
channel group number 2.
For more on static channel groups, see “Static Channel Groups” on page 20.3 and
Chapter 20, Link Aggregation Introduction and Configuration .
Examples To define a static channel group on a switch port, use the commands:
Parameter Description
group-number> <1-96> Static channel group number.
awplus# configure terminal
awplus(config)# interface port1.0.6
awplus(config-if)# static-channel-group 2