Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 378)

Switching Commands
Software Reference for x310 Series Switches
15.16 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
loop-protection timeout
Use this command to specify the Loop Protection recovery action duration on an
interface.
Use the no variant of this command to set the loop protection timeout to the default.
Syntax loop-protection timeout
no loop-protection timeout
Default The default is 7 seconds.
Mode Interface Configuration
Usage See the Loop Protection section in Chapter 14, Switching Introduction for relevant
conceptual, configuration, and overview information prior to applying this command.
Example To configure a loop protection action timeout of 10 seconds for port1.0.4, use the
command:
Related Commands loop-protection
loop-protection action
show loop-protection
thrash-limiting
Parameter Description
The time (in seconds) for which the configured action will apply
before being disabled. This duration can be set between 0 and 86400
seconds (24 hours). The set of 0 means infinity so timeout does not
expire.
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# loop-protection timeout 10