Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2110)

sFlow Commands
Software Reference for x310 Series Switches
81.16 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show sflow
This command displays non-port-specific sFlow agent configuration and operational
status.
Syntax show sflow
Mode Privileged Exec
Example To display sFlow configuration and operational status, use the command:
Output
Table 81-1: Parameters in the output of the show sflow command
Related Commands show running-config sflow
show sflow interface
awplus# show sflow
Figure 81-3: Example output from the show sflow command
sFlow Agent Configuration: Default Values
sFlow Admin Status ........ Disabled [Disabled]
sFlow Agent Address ....... [not set] [not set]
Collector Address ......... 0.0.0.0 [0.0.0.0]
Collector UDP Port ........ 6343 [6343]
Tx Max Datagram Size ...... 1200 [1400]
sFlow Agent Status:
Polling/sampling/Tx ....... Inactive because:
- sFlow is disabled
- Agent Addr is not set
- Collector Addr is 0.0.0.0
- Polling & sampling disabled
on all ports
Output Parameter Description
sFlow Admin Status Whether sFlow agent operation is administratively
enabled.
sFlow Agent
Address The sFlow agent IPv4 or IPv6 address for the device. sFlow
is rendered inactive whenever the agent address is not set.
Collector Address The IPv4 or IPv6 collector address to which sFlow
datagrams are sent. sFlow is rendered inactive whenever
the collector address is set to 0.0.0.0 or 0:0::0.0.
Collector UDP Port The UDP port on the collector to which sFlow datagrams
are sent.
Tx Max Datagram
Size The maximum size of the sFlow datagrams sent to the
collector.
Polling/sampling/
Tx Whether sFlow sampling and/or polling (and hence sFlow
datagram transmission) are active. If inactive the reasons
are listed.