Dot1x keytransmit – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1074

802.1X Commands

Software Reference for x310 Series Switches

41.8

AlliedWare Plus

Operating System - Version 5.4.4C

C613-50046-01 REV A

dot1x keytransmit

This command enables key transmission on the interface specified previously in Interface
mode.

The no variant of this command disables key transmission on the interface specified.

Syntax

dot1x keytransmit

no dot1x keytransmit

Default

Key transmission for port authentication is enabled by default.

Mode

Interface Configuration for a static channel, a dynamic (LACP) channel group, or a switch
port.

Usage

Use this command to enable key transmission over an Extensible Authentication Protocol
(EAP) packet between the authenticator and supplicant. Use the no variant of this
command to disable key transmission.

Examples

To enable the key transmit feature on interface port1.0.2, after it has been disabled by
negation, use the commands:

To disable the key transmit feature from the default startup configuration on interface
port1.0.2

, use the commands:

Validation

Commands

show dot1x

show dot1x interface

awplus#

configure terminal

awplus(config)#

interface port1.0.2

awplus(config-if)#