Stack virtual-mac, U set the, Command is – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 2168
Stacking Commands
Software Reference for x310 Series Switches
83.28
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
stack virtual-mac
This command enables the stack virtual MAC address feature. For more information on
this topic refer to
“Fixed or Virtual MAC Addressing” on page 82.11
. With this
command set, the value applied for the virtual MAC address is determined by the setting
of the command
stack virtual-chassis-id command on page 83.27
.
Syntax
stack virtual-mac
no stack virtual mac
Mode
Global Configuration
Usage
Note that this command will not take effect until the switch has been rebooted.
Example
Related Commands
detail
Caution
Stack operation is only supported if stack virtual-mac is enabled.
Before enabling the virtual MAC address feature, you should check that the
stack’s virtual-chassis-id is not already used by another stack in the network.
Otherwise the duplicate MAC addresses will cause problems for the network
traffic.
awplus#
configure terminal
awplus(config)#
stack virtual mac