Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1875)

SNMP MIBs
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 69.63
backupFirmware { firmware 3 } Information about the backup software version and
path.
backupVersion { backupFirmware 1 } Provides information on the backup software version
(major.minor.interim, for example version 5.4.1) that
the device will boot from. A zero will be returned if the
version cannot be determined.
backupPath { backupFirmware 2 } The full path to the backup release file that will be
used the next time the device is rebooted. The URL
must not contain whitespace characters.
Only one set operation can be executed at a time
across all SNMP users and an operation may not be
started unless the current value of backupSetStatus is
'idle'. Immediately upon executing the set action, the
system will attempt to set the new configuration path,
and the process will continue on the device until it has
completed or a failure occurs.
This object can be set with an empty string in order to
clear the current backup firmware. Otherwise, the
path should be of the form ‘flash:/filename.cfg’ or
'card:/filename.cfg'.
In order to set this object, the file must meet the
following conditions:
■
it must exist
■
it must be located in the root of Flash (on the
active master in a stacked environment) or USB
flash drive
■
it must not be the same as the configured main
release file
■ it must have a .rel suffix
■
it must pass several internal checks to ensure that
it is a genuine release file
■
in a stacked environment, there must be enough
disk space available to store the release file on
each stack member
backupSetStatus { backupFirmware 3 } Returns the status of any current operation to set the
backup boot release file. The following values may be
returned:
■
1 (idle) - there is no backup boot release setting
operation in progress
■
2 (success) - the last backup boot release setting
operation completed successfully
■
3 (failure) - the last backup boot release setting
operation failed
■
5 (syncing) - a backup boot release setting
operation is currently in progress and the file is
being synchronized across the stack
When a read of this object returns a value of 'success'
or 'failure', it will immediately be reset to 'idle' and a
new operation may be initiated if desired. A detailed
description of the last completed operation may be
determined by reading backupLastSetResult.
backupLastSetResult { backupFirmware 4 } Gives an indication of the result of the last completed
SNMP operation to set the backup boot release
filename.
Table 69-18: Objects defined in AT-SETUP-MIB
Object Identifier Description Object Identifier