Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1133
Authentication Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
43.7
The type parameter specifies whether multiple different VLANs can be assigned to
supplicants attached to the port, or whether only a single VLAN can be assigned to
supplicants on the port. The type parameter can select the port base VLAN or the MAC
base VLAN from the RADIUS VLAN ID. This can be used when the host-mode is set to
multi-supplicant. For single-host ports, the VLAN ID will be assigned to the port. It is not
supported with the Guest VLAN feature. Display the ID assigned using a show vlan
command. For multi-host ports, the VLAN ID will be assigned to the MAC address of the
authenticated supplicant. The VLAN ID assigned for the MAC Base VLAN is displayed using
the show platform table vlan command.
Examples
To enable the Dynamic VLAN assignment feature on interface port1.0.2, use the
commands:
To disable the Dynamic VLAN assignment feature on interface port1.0.2, use the
commands:
Validation
Commands
show dot1x
show dot1x interface
show running-config
Related Commands
awplus#
configure terminal
awplus(config)#
interface port1.0.2
awplus(config-if)#
auth dynamic-vlan-creation
awplus#
configure terminal
awplus(config)#
interface port1.0.2
awplus(config-if)#
no auth dynamic-vlan-creation