Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1516)

EPSR Introduction and Configuration
Software Reference for x310 Series Switches
57.34 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Step 5: Assign a priority to the ring instance (on Transit Node F)
Step 6: Add the physical port1.0.1 to VLANs 6 and 40 (on Transit Node F)
This step is mandatory on transit nodes that connect to a common segment, and good practice on other
transit nodes.
awplus(config-epsr)#
epsr green priority 120 Set the ring instance priority to the priority selected
for the ring 120.
awplus(config-epsr)#
exit Exit the EPSR Configuration mode.
awplus(config)#
interface port1.0.1 Specify the physical interface (port1.0.1) that you
are configuring and enter the Interface Configuration
mode.
awplus(config-if)#
switchport mode trunk Set the switching characteristics of this port to Trunk
mode.
awplus(config-if)#
switchport trunk allowed vlan add 6 Enable VLAN 6 on this port.
awplus(config-if)#
switchport trunk allowed vlan add 40 Enable VLAN 40 on this port.
awplus(config-if)#
switchport trunk native vlan none Remove the native VLAN
awplus(config-if)#
exit Exit the Interface mode and enter the Global
Configuration mode.