Show auth-web supplicant interface – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1208

Authentication Commands
Software Reference for x310 Series Switches
43.82
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
show auth-web supplicant interface
This command shows the supplicant (client device) state for the Web authenticated
interface, which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port. This command shows a summary when the optional brief
parameter is used.
Syntax
show auth-web supplicant interface <interface-list> [brief]
Mode
Privileged Exec
Examples
To display the Web authenticated supplicant on the interface port1.0.3, enter the
command:
To display brief summary output for the Web authenticated supplicant, enter the
command:
Parameter
Description
The interfaces or ports to configure. An interface-list can be:
■
an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
■
a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen;
e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2, or
po1-2
■
a comma-separated list of the above;
e.g. port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
brief
Brief summary of the supplicant state.
awplus#
show auth-web supplicant interface port1.0.3
awplus#
show auth-web supplicant brief