Log outputs – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 270

Debugging and Logging
Software Reference for x310 Series Switches
9.4
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
Log Outputs
The following types of logging output are available:
■
buffered
■
permanent
■
terminal
■
console
■
host
■
Buffered log
The buffered log is a file stored in RAM on the device. Because it is stored in RAM its
content does not survive a reboot of the device. A device can only have one instance of
the buffered log. The buffered log is enabled by default and has a filter to include
messages with a severity level of ‘notifications’ and above. The buffered log can be
enabled or disabled using the commands:
Additional filters can be added and removed using the commands described in
buffered (filter) command on page 10.8
:
The following log buffered commands are available:
awplus#
configure terminal
awplus(config)#
awplus(config)#
no log buffered
awplus(config)#
log buffered {facility|level|msgtext|program}
awplus(config)#
no log buffered {facility|level|msgtext|
program}
Displays the entire contents of the buffered log
show log tail
Displays the 10 most recent entries in the buffered
log.
show log tail <10-250>
Displays a specified number of the most recent
entries in the buffered log.
Displays the configuration of all log outputs
Specify the amount of memory the buffered log
may use.
Remove the contents of the buffered log (and
permanent log if it exists)
Remove the contents of the buffered log only
Restore the buffered log to its default configuration