Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1377)

Secure Shell (SSH) Introduction
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 52.11
Connecting to a Server and Running Commands
To connect to a remote SSH server and execute a command, use the command:
By default, the SSH client attempts to use SSH version 2 with the SSH server. If this fails, the
client uses SSH version 1.
For example, to connect to the SSH server at 192.168.1.2 as user “john”, and execute the
command “show sys”, use the command:
Copying files to and from the Server
You can use either the SCP or SFTP client to transfer files from a remote SSH server. Use the
command:
For example, to use SFTP to load a file from the SSH server 192.168.1.2, onto the flash
memory of your device, use the command:
To upload files to the SSH server, you must use SCP. For example, to upload the file
bobskey.pub as the user “bob”, use the command:
For more information see Chapter 6, Creating and Managing Files .
Debugging the Client
Information which may be useful for troubleshooting the SSH client is available using the
SSH debugging function. You can enable client debugging while the SSH client is
functioning. Use the command:
To disable SSH client debugging, use the command:
awplus# Syntaxssh [ip|ipv6][{[user ]|[port
<1-65535>]|[version {1|2]}}]
[]
awplus# ssh user john 192.168.1.2 “show sys”
awplus# copy
awplus# copy sftp://192.168.1.2/key.pub flash
awplus# copy flash:/bobskey.pub scp://[email protected]
awplus# debug ssh client [brief|full]
awplus# no debug ssh client