Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 808)

MLD and MLD Snooping Introduction and Commands
Software Reference for x310 Series Switches
32.24 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
ipv6 mld snooping fast-leave
Use this command to enable MLD Snooping fast-leave processing. Fast-leave processing is
analogous to immediate-leave processing; the MLD group-membership is removed as
soon as an MLD leave group message is received, without sending out a group-specific
query.
Use the no variant of this command to disable fast-leave processing.
Syntax ipv6 mld snooping fast-leave
no ipv6 mld snooping fast-leave
Default MLD Snooping fast-leave processing is disabled.
Mode Interface Configuration for a specified VLAN interface or a range of VLAN interfaces.
Usage This MLD Snooping command can only be configured on VLAN interfaces.
Examples This example shows how to enable fast-leave processing on the VLAN interface vlan2.
This example shows how to enable fast-leave processing on the VLAN interface vlan2-
vlan4
.
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 mld snooping fast-leave
awplus# configure terminal
awplus(config)# interface vlan2-vlan4
awplus(config-if)# ipv6 mld snooping fast-leave