Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1662)

AMF Commands
Software Reference for x310 Series Switches
60.74 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
type atmf node
This command configures a trigger to be activated at an AMF node join or leave event.
Syntax type atmf node {join|leave}
Mode Trigger Configuration
Example-1 To configure trigger 5 to activate at an AMF node leave event, use the following
commands. In this example the command is entered on node-1:
Example-2 The following commands will configure trigger 5 to activate if an AMF node join event
occurs on any node within the working set:
This command returns the following display:
Note that the running the above command changes the prompt from the name of the
local node, to the name of the AMF-Network followed, in square brackets, by the number
of member nodes in the working set.
Parameter Description
type Configure a particular type of trigger.
atmf The Allied Telesis Management Framework (AMF)
join AMF node join event.
leave AMF node leave event.
node1(config)# trigger 5
node1(config-trigger) type atmf node leave
node1# atmf working-set group all
====================
node1, node2, node3:
====================
Working set join
AMF-Net[3]# conf t
AMF-Net[3](config)# trigger 5
AMF-Net[3](config-trigger)# type atmf node leave
AMF-Net[3](config-trigger)# description description “E-mail on
AMF Exit”
AMF-Net[3](config-trigger)# active