beautypg.com

Location coord-location-id, Coord-loc-id – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1957

background image

LLDP Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

TM

Operating System - Version 5.4.4C

71.31

location coord-location-id

Use this command to assign a coordinate location to the ports. The coordinate location
must already exist. This replaces any previous assignment of coordinate location for the
ports. Up to one location of each type can be assigned to a port.

Use the no variant of this command to remove a location from the ports.

Syntax

location coord-location-id <coord-loc-id>

no location coord-location-id [<coord-loc-id>]

Default

By default no coordinate location is assigned to ports.

Mode

Interface Configuration

Usage

The coordinate location associated with a port can be transmitted in Location
Identification TLVs via the port.

Before using this command, configure the location using the following commands:

location coord-location identifier

command

location coord-location configuration

command

If a coordinate location is deleted using the no variant of the

location coord-location

identifier

command, it is automatically removed from all ports.

Examples

To assign coordinate location 1 to port1.0.1, use the commands:

To remove a coordinate location from port1.0.1, use the commands:

Related Commands

lldp med-tlv-select
location coord-location identifier
location coord-location configuration
show location

Parameter Description

<coord-loc-id>

Coordinate location ID, in the range 1 to 4095.

awplus#

configure terminal

awplus(config)#

interface port1.0.1

awplus(config-if)#

location coord-location-id 1

awplus#

configure terminal

awplus(config)#

interface port1.0.1

awplus(config-if)#

no location coord-location-id