Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 295)

Logging Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 10.23
log host (filter)
This command creates a filter to select messages to be sent to a remote syslog server.
Selection can be based on the priority/severity of the message, the program that
generated the message, the logging facility used, a substring within the message or a
combination of some or all of these.
The no variant of this command configures the device to no longer send log messages to
a remote syslog server. The IP address of the syslog server must be specified. All
configuration relating to this log target will be removed.
Syntax log host <ip-addr> [level ] [program ]
[facility ] [msgtext ]
no log host <ip-addr> [level ] [program ]
[facility ] [msgtext ]
Parameter Description
<ip-addr> The IP address of a remote syslog server
level Filter messages by severity level.
The minimum severity of messages to send. The level can be specified
as one of the following numbers or level names, where 0 is the highest
severity and 7 is the lowest severity:
0|emergencies: System is unusable
1|alerts Action must be taken immediately
2|critical Critical conditions
3|errors Error conditions
4|warnings Warning conditions
5|notices Normal, but significant, conditions
6|informational Informational messages
7|debugging Debug-level messages
program Filter messages by program. Include messages from a specified
program in the log.
<program-
name> The name of a program to log messages from, either one of the
following predefined program names (not case-sensitive), or another
program name (case -sensitive) that you find in the log output.
rsvp Resource Reservation Protocol (RSVP)
dot1x IEEE 802.1X Port-Based Access Control