Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 803)

MLD and MLD Snooping Introduction and Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 32.19
ipv6 mld query-interval
Use this command to configure the frequency of sending MLD host query messages.
Use the no variant of this command to return to the default frequency.
Syntax ipv6 mld query-interval <seconds>
no ipv6 mld query-interval
Default The default query interval is 125 seconds.
Mode Interface Configuration for a specified VLAN interface or a range of VLAN interfaces.
Usage This command applies to interfaces configured for MLD Layer-3 multicast protocols.
Example The following example changes the frequency of sending MLD host-query messages to 2
minutes:
Related Commands ipv6 mld querier-timeout
Parameter Description
<seconds> Variable that specifies the time delay between successive MLD host
query messages (in seconds). Valid values are from
1 to 18000
seconds.
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# interface vlan2
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 mld query-interval 120