Snmp-server enable trap, Snmp-server enable trap powe, Snmp-server enable – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1798: Trap, Snmp-server enable trap command on, Dhcps, Snmp-server

SNMP Commands
Software Reference for x310 Series Switches
68.16
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
snmp-server enable trap
Use this command to enable the switch to send the specified notifications (traps).
Note that the Environmental Monitoring traps are enabled by default. So you do not need
to issue this command for the Environmental Monitoring traps since these are enabled by
default. SNMP environmental monitoring traps defined in AT-ENVMONv2-MIB are enabled
by default.
Use the no variant of this command to disable the sending of the specified notifications.
Syntax
snmp-server enable trap {[auth] [dhcpsnooping] [epsr] [lldp]
[loopprot] [mstp] [nsm] [ospf] [pim] [power-inline] [rmon]
[thrash-limit] [vcs] [vrrp]}
no snmp-server enable trap {[auth] [dhcpsnooping] [epsr] [lldp]
[loopprot] [mstp] [nsm] [ospf] [pim] [power-inline] [rmon]
[thrash-limit] [vcs] [vrrp]}
Default
By default, no notifications are generated.
Mode
Global Configuration
Parameter
Description
auth
Authentication failure.
dhcpsnooping
DHCP snooping and ARP security traps. These notifications must
also be set using the
ip dhcp snooping violation command on
arp security violation command on
epsr
EPSR traps.
lldp
Link Layer Discovery Protocol (LLDP) traps. These notifications
must also be enabled using the
lldp med-notifications command on
loopprot
Loop Protection traps.
mstp
MSTP traps.
nsm
NSM traps.
ospf
OSPF traps.
pim
PIM traps.
power-inline
Power-inline traps (Power Ethernet MIB RFC 3621).
rmon
RMON traps.
thrash-limit
MAC address Thrash Limiting traps.
vcs
VCS traps.
vrrp
Virtual Router Redundancy (VRRP) traps.