Show dot1x supplicant interface – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1094

802.1X Commands
Software Reference for x310 Series Switches
41.28
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
show dot1x supplicant interface
This command shows the supplicant state of the authentication mode set for the
interface, which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port.
This command shows a summary when the optional brief parameter is used.
For information on output options, see
“Controlling “show” Command Output” on
Syntax
show dot1x supplicant interface <interface-list> [brief]
Mode
Privileged Exec
Examples
See sample output below showing the supplicant on the interface port1.0.6:
Parameter
Description
The interfaces or ports to configure. An interface-list can be:
■
an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
■
a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen;
e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2, or
po1-2
■
a comma-separated list of the above;
e.g. port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
brief
Brief summary of the Supplicant state.
awplus#
show dot1x interface port1.0.6