Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2063)

Ping-Polling Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 79.5
critical-interval
This command specifies the time period in seconds between pings when the polling
instance has not received a reply to at least one ping, and when the device is unreachable.
This command enables the device to quickly observe changes in state, and should be set
to a much lower value than the
normal-interval command.
The no variant of this command sets the critical interval to the default of one second.
Syntax critical-interval <1-65536>
no critical-interval
Default The default is 1 second.
Mode Ping-Polling Configuration
Examples To set the critical interval to 2 seconds for the ping-polling instance 99, use the
commands:
To reset the critical interval to the default of one second for the ping-polling instance 99,
use the commands:
Related Commands fail-count
normal-interval
sample-size
show ping-poll
timeout (ping polling)
up-count
Parameter Description
<1-65536> Time in seconds between pings, when the device has failed to
a ping, or the device is unreachable.
awplus# configure terminal
awplus(config)# ping-poll 99
awplus(config-ping-poll)# critical-interval 2
awplus# configure terminal
awplus(config)# ping-poll 99
awplus(config-ping-poll)# no critical-interval