Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1953)

LLDP Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 71.27
location civic-location-id
Use this command to assign a civic address location to the ports. The civic address
location must already exist. This replaces any previous assignment of civic address
location for the ports. Up to one location of each type can be assigned to a port.
Use the no variant of this command to remove a location identifier from the ports.
Syntax location civic-location-id <civic-loc-id>
no location civic-location-id [<civic-loc-id>]
Default By default no civic address location is assigned to ports.
Mode Interface Configuration
Usage The civic address location associated with a port can be transmitted in Location
Identification TLVs via the port.
Before using this command, create the location using the following commands:
■ location civic-location identifier command
■ location civic-location configuration command
If a civic-address location is deleted using the no variant of the location civic-location
identifier command, it is automatically removed from all ports.
Examples To assign the civic address location 1 to port1.0.1, use the commands:
To remove a civic address location from port1.0.1, use the commands:
Related Commands lldp med-tlv-select
location civic-location identifier
location civic-location configuration
show location
Parameter Description
<civic-loc-id> Civic address location ID, in the range 1 to 4095.
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# location civic-location-id 1
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# no location civic-location-id