Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 889)

IPv4 Software Access Control List (ACL) Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 35.3
IPv4 Software Access List Commands and
Prompts
Many of the ACL commands operate from sub-modes that are specific to particular ACL
types. The table
“IPv4 Software Access List Commands and Prompts” shows the CLI
prompts at which ACL commands are entered.
Table 35-1: IPv4 Software Access List Commands and Prompts
Command Name Command Mode Prompt
show ip access-list Privileged Exec
awplus#
access-group Global Configuration
awplus(config)#
access-list (extended numbered) Global Configuration
awplus(config)#
access-list standard (named) Global Configuration
awplus(config)#
access-list (standard numbered) Global Configuration
awplus(config)#
maximum-access-list Global Configuration
awplus(config)#
dos Interface Configuration
awplus(config-if)#
(access-list extended ICMP filter) IPv4 Extended ACL
Configuration
awplus(config-ip-ext-acl)#
(access-list extended IP filter) IPv4 Extended ACL
Configuration
awplus(config-ip-ext-acl)#
(access-list extended IP protocol
filter) IPv4 Extended ACL
Configuration
awplus(config-ip-ext-acl)#
(access-list extended TCP UDP
filter) IPv4 Extended ACL
Configuration
awplus(config-ip-ext-acl)#
(access-list standard named filter) IPv4 Standard ACL Configuration
awplus(config-ip-std-acl)#
(access-list standard numbered
filter) IPv4 Standard ACL Configuration
awplus(config-ip-std-acl)#