Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 799)

MLD and MLD Snooping Introduction and Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 32.15
ipv6 mld last-member-query-interval
Use this command to configure the interval at which the router sends MLD group-specific
host query messages.
Use the no variant of this command to set this frequency to the default.
Syntax ipv6 mld last-member-query-interval
no ipv6 mld last-member-query-interval
Default 1000 milliseconds
Mode Interface Configuration for a specified VLAN interface or a range of VLAN interfaces.
Example The following example changes the MLD group-specific host query message interval to 2
seconds:
Related Commands ipv6 mld immediate-leave
Parameter Description
The time delay between successive query messages (in
milliseconds). Valid values are from 1000 to 25500 milliseconds.
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# interface vlan2
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 mld last-member-query-interval 2000