Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 701)

IPv6 Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 27.23
show ipv6 neighbors
Use this command to display all IPv6 neighbors.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show ipv6 neighbors
Mode User Exec and Privileged Exec
show ipv6 route
Use this command to display the IPv6 routing table for a protocol or from a particular
table.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show ipv6 route
[connected|database|static|summary|
|)]
Mode User Exec and Privileged Exec
Example 1 To display an IP route with all parameters turned on, use the following command:
Parameter Description
connected Displays only the routes learned from connected
interfaces.
database Displays only the IPv6 routing information extracted
from the database.
summary Displays summary information from the IPv6 routing
table.
Displays the routes for the specified address in the IP
routing table. The IPv6 address uses the format X:X::X:X/
Prefix-Length. The prefix-length is usually set between 0
and 64.
Displays only the routes for the specified IP prefix.
The IPv6 address prefix uses the format X:X::/prefix-
length. The prefix-length is usually set between 0 and
64.
awplus# show ipv6 route