Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1960)

LLDP Commands
Software Reference for x310 Series Switches
71.34 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show debugging lldp
This command displays LLDP debug settings for specified ports. If no port list is supplied,
LLDP debug settings for all ports are displayed.
Syntax show debugging lldp [interface <port-list>]
Mode User Exec and Privileged Exec
Examples To display LLDP debug settings for all ports, use the command:
To display LLDP debug settings for ports 1.0.1 to 1.0.6, use the command:
Output Figure 71-1: Example output from the show debugging lldp command
Related Commands debug lldp
Parameter Description
<port-list> The ports for which the LLDP debug settings are shown.
awplus# show debugging lldp
awplus# show debugging lldp interface port1.0.1-1.0.6
LLDP Debug settings:
Debugging for LLDP internal operation is on
Port Rx RxPkt Tx TxPkt
------------------------------------
1.0.1 Yes Yes No No
1.0.2 Yes No No No
1.0.3 No No No No
1.0.4 Yes Yes Yes No
1.0.5 Yes No Yes No
1.0.6 Yes Yes Yes Yes
Table 71-1: Parameters in the output of the show debugging lldp command
Parameter Description
Port Port name.
Rx Whether debugging of LLDP receive is enabled on the port.
RxPkt Whether debugging of LLDP receive packet dump is enabled on the
port.
Rx Whether debugging of LLDP transmit is enabled on the port.
RxPkt Whether debugging of LLDP transmit packet dump is enabled on the
port.