Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2134)

VCStack Introduction
Software Reference for x310 Series Switches
82.20 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Provisioning Error Messages
The following error messages may appear when configuring provisioning.
Removing Hardware Provisioning
Hardware capacity that has been previously provisioned and is presently unoccupied can
be unprovisioned with the no switch provision command. This removes the provisioned
configurations for hardware that has either not yet been physically added to a switch or
VCStack, or has previously existed, but has been removed.
The no switch provision command will also delete any switch bay commands with the
same unit number and all associated interfaces, as well as all configuration for that switch .
You cannot unprovision hardware that is currently installed. A no switch command will
not succeed if the unit/unit.bay location is currently occupied. For example:
The following example displays the output of a show stack that includes a provisioned
VCStack member 3 :
Table 82-4: Provisioning Error Messages (switch x [bay y] provision)
Error Message Comment
Switch %d must be
provisioned before bays can
be provisioned. %d = stack member id
% Switch %d (%s) has 0
expansion bays. %d = stack member id
%s = board class
% Board class %s is
incompatible with this
system. %s = board class from cmd line.
Indicates x610/x900 class mismatch
% switch %d is already
populated with %s. Indicates an attempt to provision a switch that
is already present.
% switch %d is already
provisioned for %s. Indicates an attempt to provision a switch that
is already provisioned.
Table 82-5: Provisioning Error Messages (no switch x [bay y] provision)
Error Message Comment
% switch %d bay %d is
currently populated by %s You must remove hardware before
unprovisioning
awplus(config)# no switch 2 bay 2 provision
% switch 2 bay 2 is currently populated by
Virtual Chassis Stacking summary information
ID Pending ID MAC address Priority Status Role
1 - 0000.cd28.5377 128 Ready ActiveMaster
2 - 0000.cd29.95bf 128 Ready BackupMember
3 - 0000.0000.0000 - - Provisioned