Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1921)

LLDP, LLDP-MED and Voice VLAN Introduction and Configuration
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 70.17
Advanced configuration
The configuration procedure above and the defaults for other settings suit most networks. Use the following
commands for fine tuning if necessary. For information about other advanced configuration for LLDP, including
LLDP timers, see
Table 70-4 .
31.
awplus# configure terminal
Enter Global Configuration mode.
32.
awplus(config)# lldp faststart-count <1-10>
By default, when LLDP-MED detects an LLDP-MED
capable device on a port, it sends 3
advertisements at 1s intervals. Change the fast
start count if required.
Default: fast start count is 3
33.
awplus(config)# lldp non-strict-med-tlv-order-
check
By default non-strict order checking for LLDP-
MED advertisements is disabled. That is, strict
order checking is applied to LLDP-MED
advertisements, and LLDP-MED TLVs in non-
standard order are discarded.
If you require LLDP-MED advertisements with
non-standard TLV order to be received and
stored, enable non-strict order checking.
34.
awplus(config)# interface <port-list>
Enter interface configuration mode for switch
ports which will have the same advanced
configuration.
35.
awplus(config-if)# lldp management-address
Override the default LLDP management address
advertised through this port if required. This must
be an IPv4 address that is already configured on
the device. To see the management address that
will be advertised, use the
show lldp local-info
command on page 71.39 .
36.
awplus(config-if)# lldp med-notifications
By default, SNMP notifications are not
transmitted. Enable LLDP-MED Topology Change
Detected notifications for these ports if required.
(SNMP LLDP traps (notifications) must also be
enabled.)
Default: LLDP-MED notifications disabled
37.
awplus(config-if)# lldp tlv-select {[]...}
Enable the transmission of one or more optional
LLDP TLVs in LLDP-MED advertisements through
this port as required. The mac-phy-config TLV is
transmitted in LLDP-MED advertisements
whether or not it is enabled by this command.
Default: all mandatory TLVs are enabled.
38.
awplus(config-if)# lldp med-tlv-select
{[capabilities] [network-policy] [location]
[power-management-ext] [inventory-
management]}
awplus(config-if)# lldp med-tlv-select all
awplus(config-if)# no lldp med-tlv-select
{[capabilities] [network-policy] [location]
[power-management-ext] [inventory-
management]}
awplus(config-if)# no lldp med-tlv-select all
Enable or disable the transmission of optional
LLDP-MED TLVs in LLDP-MED advertisements
through these ports as required.
Default: capabilities, network-policy, location,
power-management are enabled.
39.
awplus(config-if)# exit Return to global configuration mode.
Table 70-5: Configuration procedure for Voice VLAN and LLDP-MED(cont.)