Show etherchannel – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 578
Link Aggregation Commands
Software Reference for x310 Series Switches
21.12
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
show etherchannel
Use this command to display information about a LACP channel specified by the channel
group number.
The command output also shows the thrash limiting status. If thrash limiting is detected
and the thrash limiting parameter of the
thrash-limiting command on page 15.49
to vlan disable, the output will also show the VLANs on which thrashing is detected.
For information on output options, see
“Controlling “show” Command Output” on
Syntax
show etherchannel [<1-32>]
Mode
User Exec and Privileged Exec
Example
Output
Figure 21-3: Example output from the show etherchannel command
Figure 21-4: Example output from the show etherchannel command for a particular
channel
Parameter
Description
<1-32>
Channel-group number.
awplus#
show etherchannel 2
% Lacp Aggregator: po1
Thrash-limiting
Status Vlan Thrashing Detected, Action vlan-disable 60(s)
Thrashing Vlans 1 2 3 4 5
% Member:
port1.0.4
port1.0.6